Quick rolling door installation analysis

Rapid rolling shutter doors are fast and can effectively isolate indoor and outdoor air transfer. They are insect-proof, dust-proof, anti-fouling, anti-noise, heat insulation, heat preservation, etc. They are used in supermarkets, Shopping malls, industries, workshops, etc. are loved by everyone; how should fast rolling shutter doors be installed?

Step one: Install the guide rail. First, we need to use screws to install the guide rail of the brush on the side panel of the drum. The drum needs to install curtains, accessories, and rollers in advance. Assemblies of curtain shafts, motors and accessories. When installing the guide rail, make sure that the screws are tightened to ensure that they become loose during subsequent use.

Step 2: Install the infrared safety device and radar sensor. The location should be determined and installed on the appropriate guide rail. When installing the infrared sensor, the best location is some distance from the ground. 300mm, while the radar sensor is installed 2500mm above the ground; installing infrared and radar sensors requires the use of threading holes and threading tubes to connect to the vicinity of the control box to facilitate the line connection of the control box.

The third step: Install the door body of the produced fast rolling door and fix it on the wall. In order to ensure normal operation in the future, it is necessary to check the level of the ground when fixing the door, and then use an electric drill to fix the door after ensuring that the plane meets the requirements, so that there is no gap between the door panel and the ground.

After the installation is completed, you need to try running it several times to see if there are any adverse reactions. If there are other reactions, you should deal with them in time; the fast rolling door manufacturer has 10+ technologies The installer can ensure that it operates normally after installation and has a lifetime warranty if other malfunctions occur during subsequent use.