How to solve the difficult problem of lifting door?

The industrial lifting door is a kind of large and medium-sized, heavy-duty mechanical equipment door. The material discharge port body is placed under the balanced torsion spring force and the two-way interaction force of the motor. The installation of the industrial lifting door has strong professional capabilities and must be carried out by the manufacturer. Only when the manufacturer follows strict installation procedures can the door operate safely and smoothly. Improper installation of door leaves and lifting equipment may cause components to fall. Improper operation may lead to serious accidents. For the safety of workers and materials, please operate this door properly according to the following content.

Industrial logistics factory lifting door

1. Frequently Asked Questions about Electrically Opening Sliding Doors:

　(1) For electric opening and closing doors, before using electric operation, the industrial sliding door must be adjusted to a normal state by professional personnel. When the push-button electric control opens and closes the store, the door can be opened and closed, and the door can be stopped at any position within the normal opening height.

(2) The entire door must be in operation Electrically opened and closed doors can only be used within the observation range of staff. Appropriate use of control panel keys andNote that there should be no obstructions within the operating range of the door leaf.

(3) When using the control knob switch, All it takes is one gentle click. It can be released after the door is opened and closed, so there is no need to keep pressing the open and close buttons.

(4) The door leaf is operating (raising and lowered), it is prohibited to stand in the door or pass through the rebirth door leaf. Make sure the door is fully opened or closed before leaving.

(5) Do not hit the control panel hard , to prevent common failures caused by the control board

Industrial high lift door

2. Frequently asked questions about manually opening the sliding door after power failure:

(1) The manual clutch chain is driven, and the electrical control circuit of the door opener is automatically cut off, making it impossible for the door opener to operate electrically.

(2) Facing the house toward the door opener, drive the right transmission chain downward to complete the opening and closing position. Drive the left transmission chain downward to complete the closing position.

(3) If you want to repair the electrical equipment, loosen the clutch chain and move the manual clutch chain up and down when necessary. At this time, the door opener can work normally.

Fire-fighting garage lift door

Three. Frequently Asked Questions about Lift Door Maintenance:

　 (1) For maintenance of industrial lifting doors, pay attention to keeping the track clean at all times, and remove dirt that falls into the track at any time, so as not to interfere with the operation of the door leaf and cause damage to the door leaf.

　(2) Regularly maintain the quality of the remaining oil to ensure sufficient grease.

　(3) Do not pile flammable, flammable and explosive objects on the edge of the door to prevent household appliances from causing fire hazards!

　 (4) It is prohibited to disassemble or replace any components without permission to avoid risks. Once an abnormality is discovered, please contact the manufacturer immediately and dispatch professional staff to solve it

　 (5) Check the galvanized steel wire rope and springs regularly for broken wires and cracks. If serious, please contact our company in time to have the stainless steel wires and springs replaced by professional staff.