There is no need to make a separate door cover when installing metal doors in the kitchen and bathroom.

Previously about this Door covers are all involved. Generally, except for wooden doors in bedrooms, metal doors are generally chosen for kitchen and bathroom customization, especially the panoramic narrow-sided doors that are very popular nowadays.

However, during the customization process, the metal door needs to be closely connected with the basic construction, otherwise it will often cost a lot of money for just needs.

▲As shown in the picture, the bathroom is separated from wet and dry, and the inside and outside are paved with tiles, but the door opening is not paved with tiles. If this is done, it will inevitably lead to two situations.

▲First, you must install double sets of wooden doors to hold down the untiled part of the wall to meet the need for ceramic tile closing. Putting aside the method, it is wrong to install wooden doors in the wet area of ​​the bathroom. In a humid environment, time Over time, the life of wooden doors will inevitably be shortened, and their durability will be very poor.

▲The second is to use a metal door panoramic door. At this time, such tiles will require double sets to hold down the tiles, which is even more expensive. Metal double sets are not only expensive, but also lead to a certain door opening. The degree is reduced and it looks thicker visually.

▲The correct approach should be to tile all door openings, as shown in the dry and wet areas The door openings are all covered with ceramic tiles, and the metal door single cover can be installed directly on the outside of the wet area door opening.

▲As shown in the figure, the tiles in the wet area are pasted outside the door opening. The metal door can be closed with just one wire cover in the later stage, which not only saves money, but also makes it visually simpler

▲As shown in the picture, dry and wet are separated, and the door opening tiles in the wet area extend out to the dry area. Note that there is a gap at the dry and wet door openings on the right side. Because the door will be installed later, it will just hold it down, so there is no need to chamfer here. Yes. The left side just uses the thickness of the tiles to close it with a metal door cover.

▲As you can see from the picture above, the bathroom tiles are directly attached to the outside of the door opening, and then the panoramic door is installed on the outside. The set of wires just presses the closing edge of the tiles, and the door opening will not shrink, and there is no need to spend more. Making double sets of money can also be visually cleaner and simpler

▲The same principle applies to the kitchen door, but it is different from the bathroom. Because the bathroom is humid, it is absolutely impossible to make a wooden cover, but there is no water in the kitchen. The picture above shows the effect of making a wooden cover and then installing a panoramic door, black and white Contrast. In this way, the tiles can be attached to the inside of the door opening instead of the door opening. However, this method will cost more for a door cover. For users who just want to save some money, they can not use the wooden cover.

▲As shown in the picture above, the kitchen door is just pasted with ceramic tiles, and is closed directly with the cover line that comes with the panoramic door, saving the cost of the door cover.

Summary: After reading the above summary, I believe everyone understands what to do in the actual decoration, but the coordination here depends entirely on you finding a good decoration agency, otherwise forwardThere will be conflicts between the early construction and the later stages, and there may be the risk of rework.