The door frame is 3cm away from the wall, just use foam to deal with it! The owner asked: Why didn’t you mention it during the measurement?

# ideal家生活#

Nowadays, the use of partition sliding doors when decorating the kitchen is becoming more and more popular. This design not only has good permeability and is especially suitable for households where the kitchen and living room are on the same line, but its switch design also greatly saves space. With today\’s high housing prices, being able to free up even one square meter of space is extremely valuable.

Due to the layout of the house, the kitchen and living room of the neighbor\’s house are connected. Considering that they frequently do Chinese cooking, the open kitchen is obviously not suitable, so the closed kitchen is the only option. There are currently two options to choose from: one is to use a brick wall to partition and install a door. Although this can close the kitchen, it will lead to poor north-south permeability, and the door will take up about one square meter of space; the other option is Using partition sliding doors not only does not take up space, but also improves permeability, making the entire living room and dining room appear more spacious. In the end, the neighbor chose the partition and sliding door decoration plan.

I saw that foaming agent was used to fill the gaps between the door frame and the tile wall

Foaming agent The filling thickness is fully 3cm, and the surface is also bumpy

The entire door frame The caulking is not the same width at the top and bottom, wider at the top and narrower at the bottom. This is obviously an improper door.

Although the neighbors don’t know much about decoration, they are During this period, he looked at a lot of case drawings and found that the edges of other people’s door frames were all so neat, and there were noUse a foaming agent. Faced with such a result, the neighbor found it unacceptable and immediately questioned the workers, believing that the workers had not installed it correctly during installation, and demanded that it must be dismantled and reinstalled.

In response to the neighbor\’s doubts, the worker took out a spirit level and demonstrated to the neighbor. After inspection, it was found that the wall surface was not vertical when the tiles were laid, and the error exceeded 2 cm. The workers explained that due to problems with the walls, they were unable to achieve perfect alignment during installation. If installed close to the wall, there will be a gap between the door leaf and the door frame, which will also affect the opening and closing effect of the sliding door. Therefore, only certain compromises can be made in terms of aesthetics.

The neighbor found the worker\’s explanation unacceptable because the measurements taken before installation should obviously have revealed the non-vertical problem of the wall. However, the merchant did not inform this situation after the measurement, causing the problem to only appear during installation. Neighbors can also deal with the problem promptly if informed of the problem in advance, especially if the tiler hasn\’t left yet. The current situation makes people feel very passive, so the neighbor asked the installer: Why was this issue not raised during the measurement? And ask the merchant to give a reasonable explanation.

In response to this problem, it can be seen that the tile master failed to do a good job of leveling when laying the tiles, resulting in a large error in the verticality of the wall after laying the tiles. The owner also neglected to accept the ceramic tiles. According to national standards, the perpendicularity error of ceramic tiles should be within 2mm. In fact, this error can be effectively compensated by silicone without using foaming agent to fill the gaps.

Sliding door merchants have obvious problems. As the owner mentioned, when the merchant measured on site, he knew that the sliding door needed to be installed close to the ceramic tiles and there was no door cover as decoration, which imposed stricter requirements on the verticality of the wall. If the wall is not vertical enough, the door frame will not fit tightly against the wall. The merchant may choose to conceal this out of concern for the decorator\’s face, but out of self-interest, is extremely irresponsible to the owner, ultimately resulting in unsatisfactory installation results.

During the decoration process, there are indeed many details that owners need to pay attention to. Improper handling of one node may directly affect the quality of subsequent construction. So, what similar problems have you encountered during the decoration process?