Installation method of non-standard European villa door

How to install non-standard European-style villa gates? Do you know the installation method of villa gates? Nowadays, many families in townships build their own small Western-style houses, and they basically need to install a non-standard European-style villa gate. Of course, there are also many villa areas in the city, and it is also necessary to purchase villa gates, so in this article we will introduce the installation method of non-standard villa gates. Currently, the courtyard gates on the market are mainly divided according to materials:

◎Wooden doors

◎Iron doors

◎Stainless Steel Door

◎Aluminum Art Door

◎Copper Door

p>

There will be some differences in installation details due to different materials, but the overall installation methods are similar, with no more than two types:

In the middle of the door pillar Installation, referred to as mid-installation

Installation behind the door pillar, referred to as post-installation

Following the regular process will greatly improve work efficiency. It will also reduce the troubles and hidden dangers that may arise in subsequent work.

Installation method of non-standard European-style villa door

Central decoration

If the gate is installed in the middle of the pillar, then the actual width of the gate <door opening completion surface

It is impossible to generalize about how much smaller it is, and it will depend on the actual situation.

1. If it is installed up and down, the door is 7 cm narrower than the actual width of the door opening. That is, the distance between the door frame and the pillar should be 3 cm on the left and right, and the gap between the door and the door should be 3 cm. Leave 1 cm.

2. If the hinge is installed on the side of the door frame, this depends on the diameter and processing method of the concentric spheres of the hinge.

3. If the doorpost has a waistlineThe door hole is the narrowest distance of the waistline.

Rear installation

European -style villa door is installed behind the pillar, then the actual width size of the door> The door hole is completed

1. If it is installed up and down, the actual width of the door is width than the door hole, that is, the door frame of the door must be reserved from the distance between the pillars. The specific size is determined according to the door axis style.

2. If it is installed on the side of the door frame, this needs to see the diameter and processing method of the concentric sphere of the pages.

3. If the door column has a waistline, it is recommended to flatten the side of the door as much as possible, otherwise the gap between the door and the door column is too large.
Article link: http://www.fslingxing.com/