How to adjust the garage door to the proper position

1. How to adjust the garage door to the appropriate position

1. First, we open the hood of the car. Then find the door lock switch and turn it on. Then use the key to turn the steering wheel up and down.

2. Then, we turn off the car and shut down the engine. Then find the car\’s wheel and gear lever in the car, and then loosen them a little (note: do not tighten the wheel and gear lever too tightly).

3. It is to adjust the height of the car door. We can adjust it according to the actual height of the vehicle. If the height of the vehicle is relatively high, then the door handle can be adjusted upward; otherwise, the door handle can be adjusted downward. (Of course, you can also adjust it according to your own preferences)

4. After adjusting, we fasten the seat belts in the car and it’s done!

2. How to debug the garage door

1. First, determine whether the size of the garage door matches your car model; secondly, check whether the installation position is correct; thirdly, check Check whether the fixing screws are loose; fourth, check whether the installation is firm and reliable; fifth, check whether the sealing strip is damaged, etc.

2. If it is a manual lifting parking door, you need to debug it by yourself. Generally, the operating steps of the manual lifting parking door are as follows:

(1) First, turn on the automatic lifting door. Plug the power cord of the lift parking door into the power jack. Then plug the plug into the battery. Then turn on the power. Off. Then it can be used normally. (If you don’t have a battery, you will need to buy one).

(2) Pull out the rocker arm of the automatic lift parking door to the position and press the rocker down with your hand. The button on the arm makes the motor run. At this time, you will hear the sound of the motor running. (If there is noise or no sound, it means the motor is running. The speed of the motor is too low or damaged);

(3) When the motor is running, release the button and it will stop running; (If it does not stop running, the motor is broken).

( 4) In the parking state, press the button to press the rocker arm down until it touches the ground. (If there is shaking or jumping The situation indicates that there is a foreign object stuck or the limit block is damaged);

(5) When the rocker arm drops to the bottom, lift the rocker arm upward by hand until it is reset; (If there is shaking or jumping, it means The limit block is damaged).

(6) Repeat the above steps until the entire debugging process is completed and it can be used normally.