The main place where medical doors are used is the public space of the hospital. The hospital is a multi-bacteria natural environment. For special places in the hospital, the flow of people is large and dense, which is prone to collision or cross-infection. Therefore, the existence of medical doors is not only A door, and it must play a very good role in security protection.
How to use medical doors rationally so that they do not often malfunction during use, the products are durable and the safety of users is ensured?
1. When the automatic door of the hospital operating room is running, the door often opens and does not close. The main reasons include power failure, poor electrical connection, foreign matter interfering with the safety anti-pinch and generating a green flashing door opening signal, resulting in the door body constantly opening. Whether to open or close, the other reason is that the direction of opening the door is wrong.
2. When the medical automatic airtight door is running, the door opening or closing action is too slow, mainly because the setting value of the door opening or closing speed knob of the control device is too low; the walking resistance is too large, the belt is loose, and the tension Not enough to wait. Then you can adjust the door opening or closing speed knob of the control device accordingly; turn off the power, move the door leaf by hand to check whether there are obstacles in the moving parts; adjust the belt tension.
3. Over time, the air-tight electric door of the operating room may cause the friction of the rubber strip to increase and abnormal noise to appear. We can change the distance between the ground wheel and the three-sided frame to make Increase the distance between the two, and adjust the hanger wheel at the same time to adjust the door body to a position where there is no friction with the rubber strip; if the problem still persists, you can replace it with a smaller-sized silicone strip.
4. There are three parts that are prone to abnormal noise: the friction between the track and the wheel, the ground wheel under the door body, and the friction between the rubber strips. We have already talked about the rubber strip friction abnormality above. The solution to the noise is that the friction between the track and the wheel only occurs because of the long If the maintenance is not done properly, the track will easily fall into dust, which will cause friction between the track and the wheel. The solution is to add some lubricant. The abnormal sound of the ground wheel is caused by the friction between the door body and the ground wheel. Be sure to keep the ground wheel in the correct position of the door body. It can be solved below.
5. If it is a problem with the control unit, the controller and motor can run normally.
本站内容及图片来自网络,版权归原作者所有,内容仅供读者参考,不承担相关法律责任,如有侵犯请联系我们：609448834
