Installation steps of Shenzhen suspended folding doors

As the economic level improves, people\’s living standards also improve. In the past, the doors used were wooden doors, but now many places have begun to use suspended folding doors, which are characterized by their overall appearance. It is beautiful and elegant, and there is no welding on the whole and it will not rust.

What are the installation steps for suspended folding doors? Today Kaikaihong Technology will give you a brief introduction!

1. First, remove a wooden strip sealing the wooden box from the end of the suspension door machine head, and then pull the door row out of the wooden box.

2. After pulling it out, find the machine head key. Generally, the machine head key is tied with a bandage on the movable round tube of the cross bar at the end of the door row.

3. Use the key to open the machine head cover and take out the white box next to the motor. There are 2 wireless remote controls, 1 wireless remote control, and 1 clutch key.

4. The wireless remote control is used to control the operation of the telescopic door. It is small and exquisite and easy to carry. The console is placed in the guard room to facilitate the daily operations of security personnel.

5. If the \”gear rotates but the shaft does not rotate\” occurs when using the remote control to control the operation of the door, it means that the motor clutch is not closed. Insert the hexagonal clutch key in the box into the end of the shaft where the motor is tied to the chain. There is a hexagonal groove concave inward. Insert the clutch key and turn it 180 degrees to open the clutch.

6. After the motor is debugged, close the door row against the wall (the position where the door body needs to be fixed). There are three fixed parts at the bottom of the end of the door body. The first one is the door There is a corner code on the horizontal square tube in the middle of the row, which can be fixed on the wall. There is a horizontal square tube at the bottom of the end of the door row, and there are two stainless steel corner codes on the left and right ends of the inside, which can fix the door body to the ground (suitable for installation sites without wall columns).

7. After the door body is closed against the wall, based on the center of the door body, bury a circular magnet every 20 to 25 centimeters along a straight line in the middle of the door row from edge to edge on the left and right walls.

8. After burying the round magnet, bury a square magnet directly below the head stop when the door row is closed.

9. After the door body is fully extended, bury a square magnet in the first 30~100mm from the fully expanded machine head and directly below the docking part of the machine head. Can.

10. At a distance of about 1000mm from the door and the wall, at the bottom of the machine head (corresponding to the white tube [infrared reed tube]), remove the circular magnet ( A square magnet is buried 150mn in the middle of the track.

11. Connect the 220-volt power supply (2.5 square meters for the hatchback) and the voltage should not be lower than 180 volts. The three power cords correspond to red (live wire) and yellow (ground wire). line), blue (zero line). After connecting the three wires (the ground wire does not need to be connected), you are done.

Kamenhong Technology Co., Ltd. is a company integrating intelligent products (retractable doors, suspended doors, Shenzhen electric doors, intelligent parking lot charging systems, access control management systems, transportation facilities, A comprehensive enterprise integrating the design, production, sales, and system integration of new assembled aluminum alloy parking sheds, guard booths, etc., its products are widely used in real estate, properties, schools, large domestic and foreign-funded enterprises, and halls, etc.