The question I was asked three times during yesterday’s live broadcast was how to install my own way to straighten the view.

CATIA learning. A brother asked: I drew a sketch. When I drew the sketch, it was slanted, which was not what I wanted. It was not straightened. I wanted to straighten it like this. How should I straighten it? There is a way.

·If you want to straighten it like this, you can make two lines. For example, draw a sketch first. There is a line here. Just project it. Of course, it may not be a straight line. To make sure it is a straight line, select two points and draw a straight line. This must be a straight line, because when the time comes, you need to choose a straight line.

·Then draw another straight line on it perpendicular to it. How to be perpendicular to it? Select it first, right-click and select vertical, so that one is perpendicular to it, and once the two lines are made, it is obvious that even the coordinate system can be made.

·Then break it up and it will become two lines. Where do you plan to go? Here, below. Where can I place it when sketching or drawing? Position the sketch, select two lines and this line, which line is selected first, which one is parallel, so generally choose this one, select this one first, this line is parallel, which one is selected first, Which one is parallel so it can be squared up.

·AsIf you don\’t like this, you can also swap them, put h on top and v on the bottom, or you don\’t have to swap them. That\’s fine. Then once it\’s confirmed, place it in the desired position. Once it\’s straightened out, it\’s the desired position.

This method is very good. Where can it be used? You can also use assumptions when drawing. For example, when drawing an engineering drawing, you want to put it in this way. You don\’t have to draw a sketch to make it right, but when drawing, it is more convenient to put it in this way. Publish a picture, right? right. Every night is from 9 to 11pm, and it\’s already 11pm now. good.

·When drawing a picture, you usually choose a datum plane. In general, just choose a basic plane. Try it first. , generally this arrangement is not what I want, it is slanted, which is not what I want, so what should I do? Then don\’t let it go, don\’t let it come again.

·At this time, you can choose two lines. You don’t have to choose a plane. Selecting this line can be aligned just like this line. This is the reverse selection. Well, of course, you can also select it again, or you can do it like this, and do it again, this way, it will be straightened.

·In order to demonstrate more thoroughly, let’s arrange it again. Select the horizontal one first, then select the vertical one. Straight, thisThis way you can straighten it out directly.

Brothers, have you learned it?