Safety operating procedures for industrial lifting doors (industrial sliding doors)

Industrial lifting doors play a great role in improving the working environment. They mainly provide high sealing through the entire door body and the door seams on all four sides to reduce energy loss and achieve the purpose of environmental improvement. In addition, by opening windows on the door body, it is also possible to increase the indoor lighting. A pass-through door is opened on the door body to facilitate pedestrians\’ entry and exit, and to divert pedestrians and vehicles to ensure personal safety. The safe use of the lifting door is very important. First, it protects the safety of factory property. Second, if it fails, it will threaten everyone\’s life safety. Let’s talk about the safe operating procedures for industrial lifting doors.

1. Please ensure that the industrial door body is running well. The door opener is only allowed to be installed on a well-balanced door with a balance spring installed, otherwise it may cause overload damage to the door opener; be sure to ask the installer to inspect and install it during installation.

2. The installation of industrial doors and wiring must be carried out in accordance with building construction standards and electrical standards. The wire diameter is >1.5mm; the power cord must be connected to a grounded socket and is not allowed to be removed. The ground lead on the power cord.

3. A mechanical limit device or buffer booster should be installed at the end of the guide rail of the industrial lifting door door to prevent the door from sliding out.

4. The quick release handle of the industrial door is only used by personnel to install and maintain the operation of the door. It is strictly prohibited to release this handle during operation and can only be released when the door has been It is used when it is locked and there is no risk of falling due to its own weight.

5. The control box should be installed in a place where the operation of the industrial lifting door can be observed. It is prohibited to operate the remote control in a place where the operation of the door cannot be seen.

6. Please fix the industrial door control box on a wall 1.4 meters above the ground to prevent children from accidentally touching it. At the same time, keep the remote control well and prohibit children from touching it to prevent danger.

7. Before repairing or moving the door opener, please cut off the power supply and ensure that the door body has stopped.Running, locked.

8. When the door body of the industrial lifting door is in operation, pedestrians and vehicles are strictly prohibited from passing under the door body or staying under the door body. .

9. Do not pull the manual chain when opening or closing the door electrically.

10. Manual operation:

①The manual clutch chain is a backup emergency device. Please try to use it when the door opener is normal. Electric door opening and closing.

②During normal operation, never pull the manual clutch chain to avoid damaging the motor and door-opening clutch.

③ It is recommended to hang the manual chain at a height of more than 2m when not using it to avoid inadvertent contact.

④ When pulling the manual clutch chain, the force should be even and consistent, and not jerked.

11. Electric operation:

① Electrically controlled opening and closing, the door can be opened and closed, and can Allow the door to stop at any position within the normal opening height.

② When using the control switch, just press it lightly and release it after the door opens. There is no need to continue to hold the open key

③When opening the control box for operation, be sure to cut off the power to prevent electric shock (it is recommended that non-electricians do not open the box). The above is a brief introduction to the safe operating procedures of industrial lifting doors. Another reminder Before we operate, all mechanical locking devices must be opened, and the small access door must be closed and locked; the operator must not leave before the door stops, and do not use the remote control outside the operator\’s sight to avoid danger.