Are the three-car flip-top car doors sharing a motor?

Does the three-car flip-board car doors share a motor?

Recently, when a colleague of the Hayton Car Door in Kunming installed a flap car door in the underground three-car station of a villa owner, there was a column in the middle covering, and according to the specific situation of the construction site, it could be split into two warehouse doors, one large and one small. After the case was shared online, netizens asked about the two warehouses, one large and one small, whether they share a motor or each use a motor. If they share a remote control and want to open one of them, how should they set it up?

For large-span holes with three or more car seats, we have shared before that we can add columns in the middle.Install it into two-club doors, and you can also add small doors or transparent windows to the door panels with a width of about 9 meters. For the strength of the door panels and whether they will be deformed after long-term use, we will install reinforcement when leaving the factory, which also ensures that the door panels are wide, solid, durable and will not deform.

After splitting the large-span door into two or multiple car doors, you can share a motor and a remote control, or you can configure a motor at one trip, but multiple motors of the same style can match and share the same remote control. The motor is configured according to the motor power level, and the remote control is installed at the same frequency, so the number of remote control does not require a motor to be configured with a dedicated remote control. Generally speaking, each station of the Kunming Hayton Car Door Factory is equipped with two remote controls, and increasing the number of remote controls requires additional costs.

If a door with three or four seats or more is disassembled into two-clip electric flap car doors, one large and one small, or two-clip car doors of average size, the standard is two motors, with a total of four remote controls. Each remote control can either match the corresponding warehouse doors individually or set it on the same remote control to match different warehouse doors, which is a key setting we often call, but it cannot be set to the same button to operate two motors at the same time.

For the same remote control, a button can be set as a cycle key. For example, press once to operate the opening of the left warehouse door, press again to close, press the third time to open the right warehouse door, and press the fourth time to close. Because the number of keys is more complicated and difficult to operate, the key moment may even bring users an inconvenient experience. Therefore, when configuring the remote controller, we usually set the left button to the door corresponding to the left, and then turn the single key cycle on and off, such as turning on once and pressing again once. The same goes for the right button.