Wubaobo has long insisted on optimizing hardware and developing new products to provide customers with higher-quality smart devices.

In this issue, Xiaowu will introduce the installation instructions of one of the bossless smart hardware [electric door].

Related hardware equipment: password disk, power box, electric door controller, electric lock

The specific steps are as follows

1. First change the 0 of the electric door controller to com Short-circuit at 0, then connect a separate wire at 0, and tighten the screw;

2. Wire the 12v and no terminals of the electric door controller respectively and tighten the screws;

3. Loosen the screws at the nc, Gnd, 12v, and push positions of the power supply box;

4. Connect one line of the electric lock to the nc of the power box;

5. The other line of the electric lock, the line of the electric door controller 0, and the GND line of the password disk are all connected to the GND of the power box;

6. Connect the 12V line of the electric door controller and the 12V line of the password disk to the 12V of the power box;

7. Connect the no wire of the electric door controller and the push wire of the password disk to the push of the power box;