When installing industrial sliding doors, construction personnel must follow certain installation specifications to ensure the correct installation and smooth operation of industrial sliding doors. In order to enhance everyone\’s understanding, below, we will share the installation specifications of industrial doors.
1. Preparation work
Before installing Xufeng (http://www.xufengmy.com) industrial sliding doors, you must follow the installation tools and material details. Prepare the required tools and materials, including door panels, guide rails, motors, hinges, etc.
2. Review the dimensions
After arriving at the industrial sliding door installation site, you need to first measure the door opening of the industrial sliding door to be installed to confirm whether its size matches the size of the door body. If it does not match or there are special circumstances, communicate with the customer and company business personnel in a timely manner.
3. Install the guide rails
According to the design requirements, fix the straight rails and guide rail connecting plates on both sides of the industrial sliding door. Note that both sides of the connecting plates should be level, and the two straight rails should be horizontal. The distance between them is 12-18cm longer than the length of the door panel. After the straight rail is installed, the curved rail must be fixed. Note that the back of the curved rail must be level with the front.
4. Install the torsion spring
Assemble the torsion spring and the left, middle and right bracket plates on the shaft, and fix them on the lintel. Fix them as high as possible. The middle bracket plate and The shaft is fixed at 1/3. After it is fixed, pull the torsion spring apart and fix both sides of the torsion spring at 1/3 of the shaft.
5. Fixed door panel
Industrial sliding doors use a bottom wheel frame to fix the door panel below, and the upper door panels are fixed with hinges respectively. Note that each hinge must use a drill tail wire. To fix it, the texture on the surface of the door panel must be aligned to keep it beautiful.
6. Fix the motor
After the industrial door body is installed, it is necessary to install the motor of the industrial door. Pay attention to strictly following the instructions in the manual when installing the motor. That\’s it. After that, the upper and lower limits must be adjusted.
7. Install other components
Install and fix the steel wire ropes, side seals, brand names and other components on both sides of the industrial sliding door. Note that after installation, check them one by one. The steel wire ropes It is best to pull it by hand repeatedly to ensure that it runs smoothly up and down.
8. Customer acceptance
After the above installation work is completed, the garbage left on the site must be cleaned up, and the customer must come to the site for acceptance and confirm that the door body is in normal use.
本站内容及图片来自网络,版权归原作者所有,内容仅供读者参考,不承担相关法律责任,如有侵犯请联系我们：609448834
