How to install floating folding doors in residential areas?

How to install floating folding doors in residential areas? I believe many people have questions, and today Shenzhen Kaikaihong Technology Co., Ltd. will answer them for you!

1. First, remove a wooden bar sealing the wooden box from the end of the suspension door machine head, and then remove the door row from the wooden bar. Pull it out from the box;

2. After pulling it out, find the machine head key. Generally, the machine head key is tied to the movable round tube of the cross bar at the end of the door row and tied with a bandage. Author;

3. Use the key to open the machine head cover and take out the white box next to the motor. There are 2 wireless remote controls, 1 wireless remote control, and 1 clutch key;

4. The wireless remote control is used to control the operation of the telescopic door. It is small and exquisite and easy to carry. The station control is placed in the guard room to facilitate the daily operation of security personnel;

5. If the \”gear rotates but the shaft does not rotate\” occurs when using the remote control to control the operation of the door. \” condition means that the motor clutch is not closed. Insert the hexagonal clutch key in the box into the end of the shaft where the motor is tied to the chain. There is a hexagonal groove concave inward. Insert the clutch key and turn it 180 degrees to open the clutch. That’s it;

6. After the motor is debugged, close the door row against the wall (the position where the door body needs to be fixed). There are three fixed parts at the bottom of the end of the door body. The first one is the horizontal square in the middle of the door row. There is a corner code on the tube, which can be fixed on the wall. There is a horizontal square tube at the bottom of the end of the door row. There are two stainless steel corner codes on the left and right ends of the inside, which can fix the door body to the ground (suitable for those without wall pillars) Installation site);

7. After the door body is closed against the wall, the center of the door body shall be used as the standard. The left and right walls shall be buried in the middle part of the door row along a straight line every 20 to 25 cm from edge to edge. A round magnet;

8. Bury the round magnetThen, bury a square magnet directly under the stop of the nose when the door row is closed;

9. After the door body is fully extended, 30 seconds before the nose is fully expanded. Just bury a square magnet within ~100mm and directly below the docking part of the machine head;

10. At a position about 1000mm away from the door closing and the wall, the bottom of the machine head (corresponding to the white tube [infrared reed switch]) is 150mn away from the circular magnet (middle part of the track) Bury a square magnet in the position;

11. Connect a 220-volt power supply (2.5 square meters for the hatchback) and the voltage should not be lower than 180 volts. The three power cords correspond to red (live wire), yellow (ground wire), and blue (zero wire). String). After connecting the three wires (the ground wire does not need to be connected), you are done.

The above is the content of the installation method of residential floating folding doors introduced to you by the editor of Shenzhen Kaimenhong Technology Co., Ltd. I hope It will be helpful to everyone after reading it!

Shenzhen Kaimenhong Technology Co., Ltd. is a company integrating intelligent products ( A comprehensive enterprise that integrates the design, production, sales, and system integration of retractable doors, suspended doors, Shenzhen electric doors, intelligent parking lot charging systems, transportation facilities, new assembled aluminum alloy parking sheds, guard booths, etc.).