What is the order in which self-adhesive door and window sealing strips are installed?

What is the order in which self-adhesive door and window seals are installed? What is the method to prevent self-adhesive door and window seals from falling off? Next, the editor will give you a brief introduction.

1. Clean the pasted surface to make it clean, smooth, flat and dry.

2. Measure the height of the door and window, and use scissors to cut the sealing strip according to the height.

3. Remove a small piece of protective paper on the back, install the sealing strip in the correct position and press it tightly, aligning it with the upper edge as much as possible.

4. Continuously peel off the protective paper on the back, so that the sealing strip extends downward along the frame, and keep pressing, being careful not to stretch.

5. Install the horizontal sealing strip in the same step. Pay attention to the overlap of the corner joints and there should be no gaps between the joints.

6. Note: The installation position of the sealing strip at the hinge.

Self-adhesive Door and window seals Methods to prevent falling off:

1. Before installing the glass, the debris in the groove should be carefully removed, such as mortar, brick chips, wood blocks, etc. When placing the glass, it should be carefully aligned to ensure uniform space on both sides and fixed in time to prevent collisions and Displacement, violation of groove bottom.

2. Self-adhesive door and window seals should not be pulled too tight. The cutting length is 20-30mm longer than the assembly length. When installing the device, it should be inlaid in place, the surface should be straight, the glass and glass groove should be in close contact to make the force around the glass uniform, and the rubber strips at the corners should be cut off on the slope and firmly bonded at the break.

3. When filling fixed glass with sealant, self-adhesive door and window sealing strips should be used to squeeze the glass to leave an injection space, and the injection depth should not be small.at 5 mm. The glass should not be shaken before curing.

The above is for reference only. If you like this article or find it helpful to you, please share it with your friends ^_^